Overview of Data Display Features
The Deluxe Gauge Software Reflash allows much more data to be displayed, and much more control over how it is displayed. The following pieces of data can be displayed on the gauge's top and center displays:
Engine Coolant Temperature (Not previously displayable!)
Air Intake Temperature (Not previously displayable!)
Fuel Remaining Percentage (Not previously displayable!)
Clock
Voltage (Not previously displayable!)
Altitude
RPM
Speed
In addition, the needle can be configured to display the following:
RPM
Speed
Altitude (Not previously displayable!)
With the Boost and AFR Version of the Reflash installed, additional data can be displayed including the following:
AFR
Boost
The following video demonstrates the Data Display features of the gauge:
How to use the Data Display Features
Display Configurations:
A reflashed gauge has 8 different display configuration. A single display configuration defines what is shown on the top LCD display, the center LCD display, and the needle. For example, one display configuration could be RPM at the top of the LCD, Atitude in the center of the LCD, and Speed on the needle of the gauge. A separate display configuration may instead show voltage at the top of the LCD, RPM in the center of the LCD, and altitude on the needle.
Switching Between Display Configurations:
To switch between data display configurations you simply need to press the up button on the gauge. When you press the up button the gauge will show what is being shown at the top and center for a two seconds, and then show what is being shown on the needle for another two seconds. After that the data will begin to be shown on the LCD and needle of the gauge. Also, the fuel gauge will indicate which of the 8 display configurations is being switched two by lighting up a corresponding fuel bar. Note that when the gauge starts up it also indicates what is being displayed on the LCD and needle.
Changing a Display Configuration:
To change one of the 8 Display Configuration:
Switch to the Display Configuration you would like to change
Press and hold the set button
The top LCD display will begin to flash what is currently displayed in that location
Use the up and down buttons to change to the data you would like to display at the top of the LCD
Press the set button
The center LCD display will begin to flash what is currently displayed in that location
Use the up and down buttons to change to the data you would like to display at the center of the LCD
Press the set button
The top LCD will indicate that the needle's setting is being changed, and the center will flash what is currently displayed on the needle
Use the up and down buttons to configure what you would like to display on the needle of the gauge
Press the set button to save the new settings for the Display Configuration